If you are interested, please contact us!
Proper column installation is guaranteed to perform at its best and last for life. 2ml hplc vials Please refer to the following steps for proper installation:
Step 1: Check the gas filter, carrier gas, sample pad and liner to check the gas filter and the injection pad to ensure that the gas for the auxiliary gas and detector is unobstructed. If you have previously done a dirty sample or a compound with higher activity, you need to clean or replace the liner of the inlet.
Step 2: Place the nut and seal on the column and carefully cut the ends of the column.
Step 3: Attach the column to the inlet. Insert the column into the inlet depending on the instrument used. Correct and appropriate insertion can greatly ensure the reproducibility of the test results.2ml hplc vials
Step 4: Turn on the carrier gas. When the column is connected to the inlet, pass the carrier gas and adjust the column pressure to get the proper carrier gas flow rate.
Step 5: Attach the column to the detector. The installation and required considerations are approximately the same as the column and inlet connections.
Step 6: Determine the carrier gas flow and check the column installation. Note: If the column is heated without a carrier gas, the column will be damaged quickly and *.
Step 7: Column aging After the column 2ml hplc vials installation and system leak detection are completed, the column can be aged.
This is the end of the introduction of Column installation requirements. I hope it can help you.
